/*
   This is for accessing the Supra 2400zi modem at the DOS level.
   If the software you are using requires a DOS level interface,
   copy the mdm-handler file from the SupraModem disk to your l:
   directory.  Then add the MDM: entry provided below to the
   MountList in your devs: directory.

   You may specify the desired baud rate,databits,parity,stopbits
   when you open the device...
    
          mdm:set/1200/8/N/1
	  
   This would open the mdm: device at 1200 baud, 8 bits, no parity,
   and 1 stop bit.
	  
	  Allowable baud rates :  2400, 1200, 600, 300
	  Allowable databits   :   8, 7
	  Allowable parity     :   N,E,O    (None,Even,Odd)
	  Allowable stopbits   :   1,2
  
   You may specify whether you want the handler to echo the characters
   back or not.  The default will echo.  To turn off the echo...
   
          mdm:NOECHO
	  
   You may also specify whether you wish to pass everything through
   without interpretation (RAW mode).  To do this...
   
          mdm:RAW
	  
 
   You may mix and match between the baudrate setup,noecho and raw
   when opening the device...
   
          mdm:set/2400/8/e/1/NOECHO/RAW

   Note: If you attempt to startup a cli on the modem, set the modem
   up using a terminal program by issuing the commands:
   
          ATS0=1      (to answer the phone)
          ATQ1        (to turn off result codes)
	      ATE         (to turn off echo)
	   
	   
   You may then do

          newcli mdm:
   
   to startup a cli on the modem.
   	    
*/

MDM:      Handler = L:Mdm-Handler
          Stacksize = 4000
          Priority = 5
#



NOTE:  Some people have had problems making the mdm-handler work.  We are
       trying to find the solution, but at this time do not have one.  5/10/91
