
                 ADPro/MorphPlus OpalPaint Operator v1.0

NOTE: Requires OpalPaint v1.1

			INSTALLATION

To  install  the  saver, use the supplied Install script from the cli.
First  make  sure  that you set the current directory to the directory
where you extracted this archive.  You must specify the directory into
which  ADPro  is  installed, if you have assigned ADPro:  then use the
command.

       execute Install ADPro:

If  you  haven't  assigned  ADPro, then specify the path that contains
ADPro,  if  the  path name does not end in ':' then you must specify a
'/' after the path name, for example:

       execute Install dh0:graphics/adpro/
       execute Install dh0:


                    OPERATOR DESCRIPTION

The  OpalPaint Operator allows ADPro and OpalPaint to work on the same
image  resident  in  memory.   Executing  the  OpalPaint Operator will
launch  OpalPaint copy the current image from ADPro over to OpalPaint.
Once  you  have finish editing the image with OpalPaint, simply select
quit  and  OpalPaint will ask you whether you want to copy the changes
to the image back to ADPro.

Note  that  two  copies of the image need to be kept in memory at once
while  the  operator is active.  Also enough memory for OpalPaint must
be  reserved.   ADPro  will  attempt to allocate all contiguous memory
when  it  is run, to force ADPro to leave enough memory for OpalPaint,
you  must give it a MAXMEM parameter.  You should allow a spare 4 to 5
megabytes  for  OpalPaint.   For instance if you have 10MBytes or ram,
you  may  wish to use 5MBytes for ADPro and 5MBytes for OpalPaint.  To
make  ADPro  only use 5MBytes of memory, you can specify this from the
cli by typing:

	ADPro:ADPro MM=5000000

or from the workbench by adding the tooltype:

	MAXMEM=5000000




The  OpalVision  saver  module  was written by Opal Technology, if you
have  any  questions or problems please contact the OpalVision hotline
on (310) 542-2226.

                                              Martin Boyd, OpalTech.

