loop.c

 This program is a simple for(;;) loop on the ppc. Should only
 demonstrate how to compile something.
 Run: ppcload loop.elf

Trap.c
 This program causes a trap on the ppc so the ppctask causes
 an exception.
 Run: ppcload trap.elf

TaskA.c
 This program simples outputs "Task A is active"
 Can be used with TaskB to test the multitasking.
 Also uses some simple DOS calls.
 Run: ppcload taska.elf

TaskB.c
 This program simples outputs "Task B is active"
 Can be used with TaskA to test the multitasking.
 Also uses some simple DOS calls.
 Run: ppcload taskb.elf

TaskASemaphore.c
 This program outputs "0x%lx:Task A is active" with
 semaphore synchronizing.
 A public semaphore with the name "TaskSemaphore"
 is used to output 10 lines with the mentioned text.
 Can be used together with TaskBSemaphore.c to show
 the interaction between semaphore locking and multitasking.
 Run: ppcload taskasemaphore.elf

TaskBSemaphore.c
 This program outputs "0x%lx:Task B is active" with
 semaphore synchronizing.
 A public semaphore with the name "TaskSemaphore"
 is used to output 10 lines with the mentioned text.
 Can be used together with TaskASemaphore.c to show
 the interaction between semaphore locking and multitasking.
 Run: ppcload taskasemaphore.elf

TaskSignalTest.c
 This program waits for a certain signal. With the program
 tools/ppcsignaltask you can send the signal and the program terminates.
 Run: ppcload tasksignaltest.elf

CallM68kSync.c
 This program shows how PPCCallM68k is used. In this example the
 call is done synchron which should be the normal case.
 Run: ppcload CallM68kSync.elf

CallOSASync.c
 This program shows how PPCCallOS is used. In this example the
 call is done asynchron which means that the result has no meaning.
 Asynchron means that the PPC doesn`t wait until this operation completes.
 But if another normal systemcall(Not Message operation) is caused, it can
 only execute until the last job is completed.
 Run: ppcload CallOSASync.elf

Startup.c
 This program shows how to the task`s startup/exit msg mechansim to
 exit your M68k program without major synchronize problems.
 Run: Startup

Msg.c
Msg2.c
Msg2old.c uses oldstyle PPCObtainPort(not recommended)
Msg3.c
Msg4.c
Msg5.c
Msg6.c
Msg7.c
MsgCheck.c
Time.c