Go to the previous, next, chapter, table of contents.


4.3 Modem List

4.11 Modem Settings

Choose your modem within this section. The Modem Init command will be inserted automatically once your modem has been chosen.

If your modem is not in this list either:

  1. Find your modem handbook and insert the Modem Init command yourself. We would be particularly pleased if you could send us any modem intialisation commands for modems not contained within out list.

  2. Choose generic from this list. If your modem is Hayes compatible (most are!), you should be fine with this setting.

If you live within Europe, you may be required to set a different Dial Prefix for your country.


4.12 Serial Settings

If you are using an Amiga without a Surf Squirral or other serial card, just leave the "Device:" section set to serial.device.

If you are using the Surf Squirral or other serial card, you would have to select your serial device from the list. Surf Squirrel users, for example, would select "SurfSquirrel.device".

Depending on your modem you should select these baud rates:

ModemBaud Rate
14.419200
28.838400
33.657600

Also, leave the following options as follows:

OptionCheck?
Carrier DetectYES
Hardware HandshakingYES
Use OwnDevUnitNO


4.4 Groups List

4.41 Users

You usually only need a single entry in this file (for yourself), unless you want to run daemons like ftpd/telnetd that allow other users to connect to your Amiga.


4.42 Groups

You usually only need a single entry in this file (for yourself), unless you want to run daemons like ftpd/telnetd that allow other users to connect to your Amiga.


4.5 Databases List

4.51 Hosts


4.52 Protocols

Hardly ever needs to be changed.


4.53 Services

Allows a user to define a port for a service (AmiSlate etc) and then to refer to this as a name rather than just a port number.

Most programs (if they use AmiTCP services) will tell you how they should be configured within this section.


4.54 Inetd

The easiest way to describe Inetd is a daemon that allows a user to run different Internet services from specified sockets.

When an Internet stack is online the inetd daemon launches specified programs that the user has requested.

The main use for inetd is to allow programs like AmiSlate to be used across the Internet.

An Inetd Example - Installing AmiSlate

When you are installing a program within inetd the easiest way is to follow these steps.

  1. Add the name "AmiSlate" to service
  2. Choose the protocol of "tcp" from this box
  3. Add the user "root" to this box
  4. Tell idetd where the program (executable file) is! In our case we would put something like "amitcp:bin/amislate" - assuming the AmiSlate main program is contained within the amitcp:bin drawer.
  5. Lastly click this button to enable AmiSlate
Most programs that need inetd configuring will tell you how to do so within its documentation. However by following the above formula you won't be too confused.


4.55 Networks

This section contains a list of all the networks available - this is hardly used anymore, its only use being to retain backwards compatibility with very old software.


4.56 RPC

help...


4.6 Paths List

If you are a new user or Internet beginner you should leave these paths as default. These are set by NetConnect.

You can define your own drawers for downloading etc - NetConnect programs will use this information within their configurations.


4.7 AmiTCP Prefs Menus

The most important menu is the Settings menu. This allows you to import and export your ISP settings.

Import- to import new settings or data if you ISP is not within the ISP list
Export- you can use this to save your information and send to us


Go to the previous, next, chapter, table of contents.