NEW CONFIGURATION NOTES

The  following  is a description of the  new  configuration  files 
added to GenPatch ST.   

******************************************************************

'DMP7.CNF'

     This  file  contains  5 configurations that have  yet  to  be 
tested.   The  'all' configuration is blank until the others  have 
been tested.

******************************************************************

'E_SYS202.CNF'

2.02 10ram/1scaleE!2

     For E! system version 2.02.  Saves 10 ram banks and 1 scale.

2.02 8ram/16scaleE!2

     Saves 8 ram banks and 16 scales.

******************************************************************

'FIXES.CNF'

     This  file  contains  two  alternate  files  for  the  TX81Z.  
Apparently, there are two different versions of the TX81Z.  If the 
preset config doesn't work with your unit, try these.

     There  is also an Akai S612 config which correctly saves  all 
the sample packets.  The release version omitted the last one.

******************************************************************

'JUNO106.CNF'

     This   could   be  construed  as  a  fix   of   the   Juno106 
configuration.  Unfortunately, the 106 has no request for data and 
has  no  way  of  storing directly  to  memory  from  MIDI.   This 
configuration  will save and load one bank at a time  (8  voices).  
The  request set will send a patch change starting with  11.   You 
must  then  send  the patch from the 106.   This can  be  done  by 
hitting  either  digit of the patch.   You can either  hit  button 
numbers 1-8 on the right successively or hit the same bank  number 
eight times each.   When transmitting the patches back to the 106, 
the  configuration  will  send the patch,  then wait  for  you  to 
write the patch into memory (any location actually) and then  send 
the patch (any patch).   The config will then send the next  patch 
and so on.  If this seems like a lot of work, it is.  I think it's 
actually  easier to use the cassette interface.   But don't  blame 
me, blame Roland.

******************************************************************

'KORGDS8.CNF'

Korg DS-8  all   DSA

     Saves all voices and combi's.

Korg DS-8 all vcsDSV

     Saves all voices.

Korg DS-8all cmbiDSC

     Saves all combi's.

******************************************************************

'ROLAND50.CNF'

Roland D-50 bulk D50

     Saves all data with handshaking.   Synth must be set to  bulk 
dump ready to save or bulk load ready to load.

Roland D-50 1way D50

     Saves  all data without handshaking.   You must set synth  as 
above.

******************************************************************

'RX21.CNF'

RX21 all data   RX2

     Untested configuration to save all data.

******************************************************************

'TX_CHANS.CNF'

     This  file  contains eight configurations for  use  with  the 
TX816  rack.   Each file is set to receive/transmit on a  specific 
channel.   Using these configs in a multi-block file allows you to 
load an entire TX816 rack without stopping to specify channels  at 
transmit time.

******************************************************************