SEAGATE TECHNOLOGY, INC. Technical Support Bulletin Board 408/438-8771 [300-9600 HST, MNP 3/5, N-8-1] (C)opyright 1990 Swift SCSI ST-1126N (94351-126) ÚÄÄÄ\ ³ O ³ 5 ³ O ³ G ³ O ³ G ³ O ³ 12 .................... o o o o o o ÀÄÄÄ/ 1................... o o o o o o ÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍÍ 4 2 1 ³ ³ ³ ÄÄÂÄÄ ³ ³ ÀÄ Synchronized Spindle Terminator Power Select ³ ³ ÀÄÄÄ Motor Control Header located on the side ³ ÀÄÄÄÄÄ Enable Parity Checking ÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ ÀÄÄÄÄÄÄÄÄÄ Drive ID, binary - use (Back) A B (Front of drive) ID 0 (no jumpers) for C D single drive install A-B Terminator power from Drive A-C Terminator power from Bus ST-1126N 94351-126 Swift UNFORMATTED CAPACITY (MB) ________________126 FORMATTED CAPACITY (29 SECTORS) (MB) _____111 ACTUATOR TYPE ____________________________VOICE COIL TRACKS ___________________________________7,476 CYLINDERS ________________________________1,068 HEADS ____________________________________7 DISCS ____________________________________4 MEDIA TYPE _______________________________THIN FILM RECORDING METHOD _________________________RLL TRANSFER RATE (mbytes/sec) _______________1 INTERFACE ________________________________SCSI TPI (TRACKS PER INCH) ____________________1,350 BPI (BITS PER INCH) ______________________22,840 AVERAGE ACCESS (ms) ______________________15 SINGLE TRACK SEEK (ms) ___________________4 MTBF (power-on hours) ____________________70,000 POWER REQUIREMENTS: +12V START-UP (amps) _2.5 +12V TYPICAL (amps) __0.7 +5V START-UP (amps) __0.75 +5V TYPICAL (amps) ___0.4 TYPICAL (watts) ______11 MAXIMUM (watts) ______34 BUFFERED STEP PULSE RATE (micro sec) _____6-200 WRITE PRECOMP (cyl) ______________________N/A (1069) REDUCED WRITE CURRENT (cyl) ______________N/A (1069) LANDING ZONE (cyl) _______________________AUTO PARK IBM AT DRIVE TYPE ________________________0 or NONE Already low-level formatted at the factory. Seagate reserves the right to change, without notice, product offerings or specifications. (6/26/90)